How to Clean Your Keurig (and When)

It can be tricky to figure out how to clean your Keurig, but it’s important work. If your household is like mine, your pod coffee maker runs anywhere from three to seven times per day. All of that use can cause buildup and gunk, which can affect the taste of your coffee and the lifespan of your machine. But with proper maintenance and a dedicated routine, cleaning is a breeze. Here’s everything you need to know about light daily cleaning as well as deeper cleans.

Be sure to check out our related buying guides, including the Best Pod Coffee Makers, the Best Coffee Machines, the Best Coffee Subscriptions, and the Best Milk Frothers.

Daily Maintenance

To clean the housing of your Keurig coffee maker or other pod machine, just take a damp cloth and wipe down the outside. You can clean the K-Cup holder and needle by brushing or vacuuming away any loose debris like coffee grounds—be careful near the needle part since, obviously, it’s sharp.

Some machines come with a needle cleaning tool that you insert into the top and bottom of the needle, and a few people on various forums have used a paper clip instead. Some machines have removable pod holders that can be soaked in hot water. It’s always a good idea to refer to your specific model’s user guide, and you’ll probably want to unplug your machine beforehand.

To clean your drip tray and water reservoir, remove them and wash them by hand with hot, soapy water (though avoid using too much dish soap to prevent buildup). If your machine came with a carafe, wash it by hand or pop it in the dishwasher if it’s dishwasher-safe. Let them air dry or wipe them down with a lint-free towel after rinsing them off. You should be replacing the fresh water in your reservoir often, especially if it’s been sitting for a while. If your machine has a water filter in its reservoir, replace it every two to three months. Most machines with these types of filters have maintenance reminders—heed them!

For cleaning out the internal bits and pieces, you can use something like a Keurig Rinse Pod, which helps to flush out any excess oils or flavors that might be lingering. They are especially handy after brewing with flavored K-Cups like hot cocoa or some coffee varieties. You can also just run a hot water cycle every so often, which is a particularly good idea if you haven’t used your machine for a few days.

Deeper Cleaning and Descaling

Some manufacturers recommend using filtered water or distilled water instead of tap water in your reservoirs, but I’ve always used tap water with the knowledge that I might have to clean my machine more frequently. You should deep-clean or descale your pod coffee maker every three to six months, or possibly more often if you notice hard water stains, calcium deposits, or mineral buildup, or your machine prompts you to deep-clean it.

You can do this a few ways. For the DIY method, fill your water tank with white vinegar and water (about half and half) and run large-capacity brew cycles until the reservoir is empty; Halfway through, consider letting the vinegar solution soak for a while, around 20 to 30 minutes. Follow up with a few rinsing cycles using clean water until the vinegar smell is gone. Alternatively, you can use a dedicated Keurig descaling solution according to the instructions on the bottle. That solution can be used on non-Keurig machines too. Make sure your machine is fully rinsed out before brewing your next cup of coffee.

It’s important to perform these deeper cleaning cycles on a regular basis to ensure your machine lasts as long as possible. And that your coffee tastes good, of course.

Power up with unlimited access to WIRED. Get best-in-class reporting and exclusive subscriber content that’s too important to ignore. Subscribe Today.